h22 swap into a accord distributor question ???????
Thread Starter
3.0 BAR
Joined: Apr 2005
Posts: 4,889
h22 swap into a accord distributor question ???????
ok on the accord there is 3 clips that go to the distributor and on the h22 there is only 2 wtf am i sappost to do about this 
??
i searched and it has something to do with internal coil and external but i couldnt figure out how to make it work. somebody want to help a dirty nigg out of this delemma
??i searched and it has something to do with internal coil and external but i couldnt figure out how to make it work. somebody want to help a dirty nigg out of this delemma
0.5 BAR
Joined: Jan 2007
Posts: 57
Re: h22 swap into a accord distributor question ???????
When I swapped the H22A into my EG hatch the motor was a external coil setup but I had the internal dizzy. SO I done away with both. I bought the Crane cams ignition module with a MSD external cap and a Crane cams PS91 external coil. Then the motor came alive. Until now I cant get it to run since the turbo build and I get fuel in the runners and I have spark. So spark+fuel=not running. Can you take pics of the Vaccume system on intake I need pics of that to double check mine
0.0 BAR
Joined: Jun 2005
Posts: 0
From: WA
Re: h22 swap into a accord distributor question ???????
theres a few ways to do this.
the easiest and fastest and most hmt is to splice the power and ground that go to the external coil plug.
they are the thick yellow and black wires.
or, you could just get an h23 dizzy, or swapped out internals(only the wire internals. all the shaft and spline wont work in a dohc)
the easiest and fastest and most hmt is to splice the power and ground that go to the external coil plug.
they are the thick yellow and black wires.
or, you could just get an h23 dizzy, or swapped out internals(only the wire internals. all the shaft and spline wont work in a dohc)
Thread
Thread Starter
Forum
Replies
Last Post
SQUAD Enigneering
Engine Management
11
Dec 4, 2006 08:13 PM
