getting code 20
#1
getting code 20
ok well i think i know why my obd1 conv.. didnt work.. i noticed today i was getting code 20.. well i was going back over my wire tuck and cam across a clipped ground that just so happens to run to the 3 pin connector that is for the electric load deal.. i ahve been tracing wires looking fo the other clipped wire and havent found one.. can someone verify that this actually is run in conjunction with the ground distribution or is it just chassis grounded
please help!!!
please help!!!
Thread
Thread Starter
Forum
Replies
Last Post
ifly87
Engine Management
6
06-18-2006 12:38 PM
falkhen
General Discussion
18
04-18-2005 09:45 PM
djnikko
Engine Management
7
03-03-2004 09:16 PM