car/cluster: 92 Honda Civic CX

i have this cluster that has the needle on the WRONG side of the zero pin is this fixable? can you just swing the ****** back around?

can you remove the needle and put it back without it ------ up the cluster or making it read inaccurately?

 

just push it around from high to low. should be just fine

 

if im not mistaken, the needle does pull off.

 

it will never show correctly again if you do that. i did and it was a huge mistake.

 

i have already taken it off... but it was on the cluster that had the needle on the wrong side too...

how you get it back on the right way again then

 

i guess just put it back on and see how it does.

 

if its anything like the gas gauge, dont ---- with it. my buddy accidentally nicked it a little, and now its inaccurate

 

Your best bet is going to be buying a guage from the wreckers, taking it apart and putting it into your cluster.

I tried painting the needles on my cluster florescenet orange so it would illuminate at night... moved one of the needles and it never worked again. had to swap out the guage from a junker cluster into mine and it worked after that.
-Rik

 

My old integra had this same exact problem from the -----tard b/f I owned it installing indiglo blue gauges.

The gauge is probably fucked...good luck.