just make sure it has SOME oil in it and it'll be JIM DANDY! it takes about .5 seconds to push oil through the engine once its started and has oil pressure

 

but would it affect the crank because the crank isnt properly lube up. Wouldnt trying to crank it same as spinning a bearing?

 

What kind of shitty tools do you own? I've spun many different motors with drills. Buy a decent drill 3/4 HP and you should be good to go. I have a 3 speed milwakee hammer drill (obviously hammer mode is off when doing this) and I have got the motor to spin on 2nd speed ~840 rpm. (works well for the oil line prime for the turbo)

But I would drain the oil, and pour new ---- in there. You could get away with cranking it just unpug the dizzy.

 

get new oil andfilter

 

i got some gas in a car fo ralmost two years now, ill prolly just throw some treatment in it and some 93 in there. i think it should work fine

 

Jeez what do you think these jdm motors are they have been sittin for 10+ years dont worry about it and I really dont think the new gas goes bad unless someone can come up with some actaul evidence only thing is you may have collected some water in the tank but I doubt it will do any damage. I let my civic sit for over a year charged the battery and drove it around no probs

 

motor will be fine, stop being a ----

 

+1