DOHC ZC 0 to OBD1..
 

i have a doubt about this..cuz i was thinking to convering my ZC D16A9 to OBD1 tomorrow, i have Dizzy TD043U, conversion harness (4 wires connector) and P28 ecu ,i was checking a thread about this, it's necessary to remove the crank angle posicion from Exhaust cam? or doesnt?

anybody has diagram for dizzy conversion? i wast searching , not luck yet..

thx!

Re: DOHC ZC 0 to OBD1..
 

Hey Walter, you don't have to take it off the crank angle; but the obd1 dizzy has it built in. You will have to a little bit of wiring, but nothing to big. Sorry on diagram.

Re: DOHC ZC 0 to OBD1..
 

ok, was finding out some info, and yes, i can leave it disconet or just put in a rubber from B18A1.

Abuot wiring, i know..just i need diagram..

anyway thx

Re: DOHC ZC 0 to OBD1..
 

Re: DOHC ZC 0 to OBD1..
 

all you have to do it match colors...OBD0 And OBDi dizzy wire colrs are the same. Just takes some patience and color recognition skills. Its not hard, I would just repin the OBD1 dizzy to the square plu and put the two blue/grn, blu/ylw wires to the 2-pin and leave your harness like stock. It easy as hell thats what I did. Or I can sell you some adapters.

Re: DOHC ZC 0 to OBD1..
 

didnt see thread ..

i assume this is right..

http://img212.imageshack.us/img212/4444/ed4d6df4ua7.jpg