D16 Tranny Bolt Size?
I'm trying to get my D16Z6 block up onto my engine stand and I need some bolts for it, but I have no idea what size they are. Anybody know?
|
Re: D16 Tranny Bolt Size?
M12x1.25
The bottom rear hole isn't threaded so just get a long enough bolt to go through and a nut. |
Re: D16 Tranny Bolt Size?
Originally Posted by jagojon3
M12x1.25
The bottom rear hole isn't threaded so just get a long enough bolt to go through and a nut. |
Re: D16 Tranny Bolt Size?
i thought they were 14mm? its been too long since i pulled a tranny.
|
Re: D16 Tranny Bolt Size?
Originally Posted by chris
headbolts work nicely for the bottomone
dude I have a pile of those tranny bolts, didnt think of it before |
Re: D16 Tranny Bolt Size?
Thanks, after searching at every autoparts store in oshkosh with no luck. Everyone looked at me like I was asking for blinker fluid (dumbasses). So in the end I landed at the local hardware store and found them there. 3 12x1.25x60's and 1 12x1.25x100 with a bolt. $30 bucks is kinda steep, but oh well atleast I know where to go now.
|
Re: D16 Tranny Bolt Size?
I hope you didnt buy them, if you did keep you're reciept, i'll bring some over tomorrow.
I know advance has them in some bins they keep behind the counter, just go back there and start digging through them most of the employees there dont even know they exist |
Re: D16 Tranny Bolt Size?
Originally Posted by wellington
Thanks, after searching at every autoparts store in oshkosh with no luck. Everyone looked at me like I was asking for blinker fluid (dumbasses). So in the end I landed at the local hardware store and found them there. 3 12x1.25x60's and 1 12x1.25x100 with a bolt. $30 bucks is kinda steep, but oh well atleast I know where to go now.
|
Re: D16 Tranny Bolt Size?
I'm guessing he is looking at stainless, prices sound about right.
|
All times are GMT -5. The time now is 07:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands