d15 mini-me
 

Does anyone know any good sites or informaton about d15 mini-me wiring with a z6 head. It will be dropped into a 88 dx. also , are 1st gen integra rods compatable with a d15?

Peace

Re:d15 mini-me
 

You will need to do the DX to SI swap.. DPFI-MPFI wiring swap, then it will depend on what ecu you will run. If you want to run the P-28 ecu, you will have to rewire the the ecu plugs and get a new distributor (obd1 conversion) or you can run the Pm6 ecu and use a RPM activated switch to run vtec at a certain rpm. Alot of people do this since its alot easier and works. But you will need to somehow give the engine a bit more fuel when vtec kicks in. You could use a vtec controller to do this. Otherwise the car won't be getting "Optimum Performance" I highly recommend dyno tunning if you are not going to be using the p28 ecu.

The PG7 is another ecu option

Good luck

Jeff Frank

Re:d15 mini-me
 

it is possable to use the 1st gen integra rods although you have to send them to a machine shop and get them refitted to the d15 crank shaft. it is also possable to use the 1 st gen integra pistons, while it boots your compression to about 12:1 it is very ify on the valve clearance. the 12:1 is not street legal.