cleared all codes, still have a problem?
 

what up guys, i just took my b16 out of the rex for rebuild and dropped in an ls, it had a numerous amount of codes when i waspped it back out and i fixed them, but my problem is when i drive the car i have to drive it in 1/4 thotrrle for it to be smooth, if i go anymore then that, half or full the car sounds like its getting on it but hardly moves at all its actually slower then when goin 1/4 throttle, anyone have any idea what this could be?

Re: cleared all codes, still have a problem?
 

sounds like timing

Re: cleared all codes, still have a problem?
 

i pulled the motor out of a integra that ran fine, didnt change anything but the plugs just put it in, im stumped ???

Re: cleared all codes, still have a problem?
 

what ecu did u use

Re: cleared all codes, still have a problem?
 

integra ecu

Re: cleared all codes, still have a problem?
 

You didnt touch the dizzy? that's what it soudns like to me. It's either timing or fuel and if you didnt touch anything timing is more likely.

Re: cleared all codes, still have a problem?
 

think i should try a new cap, im also think maybe my vacuum lines are fucked, i used a diagram but i dunno its pissing me off ..... driving this bitch 1/4 throttle sucks