RNPoo7

My car was boosted and I put her back to stock.

Now the car won't start

I'm thinking

1) Out of gas - just put some in so cross this out

2) Injectors need to be cleaned



CAn injector clip wires be reversed, I don't think they can, but I am not sure.

Any ideas?

djfob

Does it crank........some info on the previous turbo setup would help a bit.

RNPoo7

It's a 2000 GSR. It was tuned by JD via Uberdata in a chipped OBD I P28

I was running Precision 880cc injectors with OBD I clips, had an aftermarket fuel rail and fpr.

When i try to start it, it tries but doesnt actually start. It acts just like when you do a compression test.

I have a feeling the injectors are not squirting since they have been sitting in my room for 2 years.

Let me know if you hvae any questions and i'll let you know asap.

But I can't really think of any other reason why it won't start.

TIA

BoosTedZSix

did you have a resistor box for the 880's? dumb question but did you take it out? try new injectors? did you re-burn a stock chip?

RNPoo7

I took off the resistor box. I am now running my stock P72 OBD II ecu.

djfob

recheck your injector wiring, do you smell fuel?

RNPoo7

Well I got that bitch to fire up. It started


BUT, i need new o rings for the injectors. I noticed there was a cel, i couldn't check it, because it the injector kept on squirting.

Sol i'll find out when i get new O rings.

BoosTedZSix

what was the problem?

RNPoo7

Not sure...

I cleaned the injectors and there was a wire that seemed to be loose from where I disconnected the resistor box, so i dont know which caused the problem.

jacob

i love it when the problem is minor and doesnt cost a bajillion dollars to fix