Can't get B16 started
 

So I just installed a skunk2 intake manifold on a guys B16, and I can't get the damn thing to start. The car ran fine before it was parked last week, so I'm stumped. I am getting fuel to the fuel rail, I have spark, timing is good, I'm using the injectors that were in the car when it was running. I have even changed injectors, fuel rails, checked the main relay and fuel pump. I have checked all the ground wires, including the one on the thermostat housing. I have even switched ecu's. Anyone have any ideas?

check the tps. alot of people hook them up wrong
also did you reuse the intake gasket.
to be completly honest though none of us will be able to tell you what you did wrong

switch the MAP and TPS plugs, u may have hooked them up wrong they look exactlyt the same

I checked the tps and map wires and I have them correct. I also used a new intake manifold gasket as well.