Can I reuse my stock wrist pins when replacing piston?
Well, I found some cheap pr3 replacement pistons for my #1. Was wondering if I will need to replace the wrist pin along with the rings and bearings?
|
Re: Can I reuse my stock wrist pins when replacing piston?
depends on how good your machinist is at using the heater and press.......
|
Re: Can I reuse my stock wrist pins when replacing piston?
you'll probably actually have to. On forged pistons the wrist pins are sliding so you can reuse them, but with cast piston's the pins are a little bit larger than the hole for them in the piston, which means that if you re-use old used wrist pins then they won't hold tight onto the piston and rod which could me it slides to the side and scratch's up your cylinder wall's... burn's oil....looses comp...and can screw up your rings.
|
Re: Can I reuse my stock wrist pins when replacing piston?
ok, I' guess I'll just add that to the list.
|
Re: Can I reuse my stock wrist pins when replacing piston?
blah just ask your machinist...i reused mine since they came out all purdy
|
Re: Can I reuse my stock wrist pins when replacing piston?
I reused mine in my bike last time I rebuilt it. I fucked one of the new ones up so I kinda had to. :l
__________________ Best Car Insurance | Auto Protection Today | FREE Trade-In Quote |
Re: Can I reuse my stock wrist pins when replacing piston?
um, new pistons come with pins, you can get them for like 100 bux/set on ebay.
|
Re: Can I reuse my stock wrist pins when replacing piston?
Are you talking about the pistons and rods I sent you?
You do not have to buy anything new except the rings and maybe the bearing if they arent within spec. you only replace the wrist pin when u remove the pin from the piston/rod. |
Re: Can I reuse my stock wrist pins when replacing piston?
heh, I made this post before I bought those from you. I was planning to buy one piston and just swap them out at first. I will be getting new bearings on #1 fo sho. I doubt the bearings on the rods you send will be within spec for mine...we'll see. it would be awesome if they were.
|
Re: Can I reuse my stock wrist pins when replacing piston?
heh well i didnt send the bearings remember ;)
pistons/rods/rings your bearing will probably work :y |
All times are GMT -5. The time now is 04:18 AM. |
© 2024 MH Sub I, LLC dba Internet Brands