cam seal replacement
Today I decided to replace my leaky OEM cam seal but in the process I realized that I need to take the last part of the cam of witch has to bolts. So my question is what are the torque specs. for putting them back.
PS- B18A |
Re:cam seal replacement
|
Re:cam seal replacement
AbaZ- Yes. So,I Should only take off the EX. Bearing cap? In order to remove the cam seal.
Thanks. :) |
Re:cam seal replacement
Ok, you can sneak cam seals out without ------- doing the whole timing belt like your suppose to.
-Bring the Engine to TDC -Mark the Belt to the cam gear (with touchup paint or whatever) -Now zip tie the belt to the cam gears (yes both of them) I use 4-6 zip ties. -Now loosen the cam bolts (not sure if you have to take the intake cam gear off too, might have to. I usually just do them both. -Now slide 1 gear off at a time, be VERY careful doing this so you dont drop the keyway down the front side of the engine. -Now the gear is off replace the cam seal. Besure to clean the head real good where the seal is at. -Lightly lube the inside of the cam seal -Lightly put silicone on 2 sides of the seal -Put the seal back into place, be sure the seal is sitting straight, & make sure the spring didnt pop off on the seal. - Now re-install its a bit tricky ;) I am the master of doing this ----, because I hate doing timing belts, especially if ya got AC/PS. FLATRATE 8) |
Re:cam seal replacement
Sounds kinda tricky but I will try to follow your guide-lines and hope for the best.
Thanks again. ;D |
All times are GMT -5. The time now is 06:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands