cable transmission on hydraulic system
 

I need a new transmission, and I came accross a b16 cable one, my system is hydraulic, what would I need to use this transmission, would I be able to use the same clutch? does anyone (hassport) sells a kit to make this happen? will I be able to use the same LSD ?

Re: cable transmission on hydraulic system
 

There are two different cable b16 trannies. Small shaft and big. The spline that the clutch slides on will tell you which one it is. If it is the big spline, it should work with your current clutch setup.

You could probably convert your pedal-rack to a cable setup pretty easy. Go to the junkyard and get one off a ef. Then you'd need a clutch cable from an da integra. Civic ones are too short.

I couldn't tell you which lsd's are interchangeable. Sorry

Re: cable transmission on hydraulic system
 

i have an ys1 in my 94 civic, via hasport conversion, its ok but i wish i had the tiime to do a full cable conversion

next question is which throwout bearing would I use if I keep the clutch from the hdraulic system and use the cable tranny?

good question...would like to know also...

Well I have a s1 tranny in my ef with a cable throw out bearing and hydro pp and flywheel thm the disk is for a cable and it all works fine

ok thanks ! kind of answer I was looking for, but is it a B SERIES MOTOR?

Yeah b16a

hasport makes a kit for this

I ordered the kit yesterday, then had to cancel the order, I guess I am stuck with the LS tranny. I hate these long gears.