Bottom end balance?
When you guys build a bottom end with Eagle rods/SRP pistons do you get the rotating assembly balanced or do you not bother? I'm currently doing an A6 low compression and was thinking while the blocks away being bored maybe i should get it balanced too.
your views please... |
Re: Bottom end balance?
Since your're there you might as well balance it all. When I put eagles and srp's into my z6 i had it balanced, it was only 195 bucks. My machinist also said that if it wasn't balanced it would beat the ---- out of hte main bearings. just my 2 cents
|
Re: Bottom end balance?
most manufacturers balance pistons to the gram before they pack them up for you
rods are a bit more iffy i would never balance the crank again. Did it once, and that ---- was wobbling like a frisbee. |
Re: Bottom end balance?
I do myself as I figure why not just spend the little extra and do it right.
|
Re: Bottom end balance?
Originally Posted by Ravage70
most manufacturers balance pistons to the gram before they pack them up for you
rods are a bit more iffy i would never balance the crank again. Did it once, and that ---- was wobbling like a frisbee. |
Re: Bottom end balance?
you can do rods/pistons yourself, it's the spin balance that's tricksy.
Originally Posted by jundoc
your machine shop probably didnt do it right if it was wobbling....
|
All times are GMT -5. The time now is 09:27 AM. |
© 2024 MH Sub I, LLC dba Internet Brands