d16z69psi

I bent my wheel studs , by removing my axles. should I just replace the hubs and bearings? any tips? or anything I should look out for?

89 crx Dx

crx2fast

how the hell did you pull that one off
anyway just replace the stud/s, there like a dollar

d16z69psi

I had a thick *** crowbar in between them, then took a big *** breaker bar to the axle nut! now all the studs are out of place and move around.

juli0_bustamante

mann that sounds like your really buff or really retarded..j/k

unfortunately that isnt quite the easy/fast fix...the studes wont come off unless you remove your hub and take it to a machine shop to have them removed. change your bearing while your at it

RENR

juli0_bustamante

Pinchi Renr DONDE ESTABAS EL DOMINGO PASADO?

quadnie

Are you referring to the studs that hold the lug nuts that hold the whell on?

They are about a dollar each, knock those bitches out thread in new ones. I've done it hundreds of times to many diff vehicles (I would have to say that the ford explorer has been the biggest pain in the ***).

d16z69psi

Sounds like a plan. I appreciate the tips.
I should invest in a compressor and air impact gun. Sometimes I just don’t know my own strength.

juli0_bustamante

all you need is a pimp as breaker bar and some long as tube to break the axle bolt loose, after that its all good!

Guy-Fast

you just cant knock out studs on honda hubs. You need to grind the hub down slightly to remove/install the studs.