TO bearing question
#1
TO bearing question
my tranny is in the car, the engine isnt
i unbolted the bolt on the arm of the TO bearing to slide the pin out so i can replace it, but now it shifted so i cant get the bolt back in, and i cant slide that arm/pin out to replace the TO bearing
anyone have any suggestions? that DONT require dropping the tranny
i unbolted the bolt on the arm of the TO bearing to slide the pin out so i can replace it, but now it shifted so i cant get the bolt back in, and i cant slide that arm/pin out to replace the TO bearing
anyone have any suggestions? that DONT require dropping the tranny
#5
Re: TO bearing question
Originally Posted by Zeniceguycrx
if your engine is out undo the 6 bolts holding your tranny in and look at it on as table, and fot the to bearing iv always just poped the spring off and on, never undo any bolt?
#8
Re: TO bearing question
Originally Posted by Mista Bone
remove radiator to slide the cross shaft out to change the TO.
once slid back in, lift up on the clutch arm to align the bolt holes.
once slid back in, lift up on the clutch arm to align the bolt holes.
#9
Re: TO bearing question
well i got the bolt back in the shaft, never got it out to replace it
do the D-series trannys have to be dropped to change the throw out bearing? i cant understand why they would need to be.. if i cant replace it i'll just reuse the old one i guess
do the D-series trannys have to be dropped to change the throw out bearing? i cant understand why they would need to be.. if i cant replace it i'll just reuse the old one i guess