Okay, I got my clutch/brake installed, hydraulic reservoir, etc... Now I need to do the wiring to finish my auto to manual conversion for inside the car. I'd like to start putting my dash in. I researched it and cant find a good enough thread on the wiring you have to do. I know some of you have done this, I'd appreciate some help with the wiring. Thanx!!!!!

 

Here's one for 96-00 Honda http://www.honda-tech.com/zerothread?id=1337459
You never said what car you have, so.....

 

two things to wire.

1. clutch shoved in so starter will turn thingy

two fat wires on the shift selector from the auto, attach one to each side of the switch on the clutch pedal, or permanently attach them, or toggle switch them

2. reverse lights

i dunno i never did that ----, reverse lights are for pussies.

 

LMAO. Nice. LOL.


JP

 

man you're a worse post ----- than frank, sinister, jaykew, and myself all combined into one i swear.

 

You have over 5000 posts. That's irrelavant. It was funny.


JP

 

5 months vs. almost a year and a half....dont worry you're catching up.

 

the only wireing i did was the auto shift selector and i really didn't "wire" it, just slid the thing into place so my key will stil come out and then slapped some JB love all over it so it wouldn't move.

the clutch switch and reverse lights are for pussies .

and for the record your both post -----s

 

http://brokenlimits.com/howto/howtoa...automanual.htm

All the wiring info you need is at the bottom of that page.. its for 92-95 civic so I hope that is what your looking for.. I have a write up saved on another forum if you are working on an 96-00 civic...

 

that guy should get an award for a shitty write-up.

1. that connecting wires so you can remove the key, never did that, key comes out fine. Didn't really feel the need to have my key come out of the ignition whenever I needed to. When its off works just fine.

2. his reverse light directions are total ***. Is he saying to tap into the two wires from the reverse sensor on the tranny, if so, which wire is which? lack of detail, poop on that.

shitty random pics in only a couple of places.

3. You don't need all that pedal assembly.

You need:
1. clutch pedal assembly.
2. narrow brake pedal arm only, just pull the pin, slide the fat one out, and slide the narrow one in