auto to manual
 

i have an auto eg and right now i'm putting in a b18b 5spd. we already got the motor/tranny/axles/linkage in.

are there any wires i need to cut or move on the engine or ecu side(becuz the chassis is an auto)?

is there a way to modify the stock tranny mount? if not where can i buy one?

also does the clutch pedal bolt right in? or do i need to weld it in?

where can i find a clutch master cylinder and lines from? i've checked ebay but the auctions don't end for awhile? i'm trying to get them asap.

i'm gonna try to run a gsr radiator, i know it is tall but i think i can relocate the bottom mounts to make them work. has anyone ever done this?

Re:auto to manual
 

go to the yard to get the parts your missing, you will aslo need to change the pass side tranny mount to a manual mount you can order it from honda for about 34 bucks. it will require you to weld a new one in.

Re:auto to manual
 

check out these write ups.
good luck!

http://www.torontocivics.com/article...to-manual.html
http://hybrid2.honda-perf.org/tech/autoconvert.html

Re:auto to manual
 

The hybrid link also has a write up on the teg rads. in eg's pretty simple. The conversion I would say is a little bit on the diffcult side