Anyone replaced thier rear main seal?
 

i'm starting to put the block back together, and i'm have a BITCH of a time gettnig the rubber rear main outa the rear cab. anyone replaced on of these. i go on majestic, and i can oder a new rubber seal, but i'll be damn if i can get the old on out... i'm gotten lots of PARTS of it out... but there has to be a better way.

Re:Anyone replaced thier rear main seal?
 

Your talking about the rubber seal that goes around the crankshaft right? (the rear main seal...) When ever I do these I use a small thin screwdriver and tap around the seal at an angle until you can work it out. Don't scratch up the crank though!!! Then when your going to put the new seal back in, make sure you have the correct side facing out,and put a little grease around the inside of the seal and use a big socket or punch to tap it in evenly. Make sure you get the seal to sit where it should. These things can leak real easy if it's not in right, and it's a bitch to take everything back out just to change the seal again... Just make sure you take note which side was facing out and which side was in. The part with the spring should be facing in I beleive. Good Luck

Re:Anyone replaced thier rear main seal?
 

WOOHOO!!! 100 points to you. i was prying on it with my screwdriver, buti was afraid to tap it in with my hammer. i tokk your advice, and 2 minutes later it's out, thanks again. MAJOR HELP!

Re:Anyone replaced thier rear main seal?
 

No problem, I used to work at a Tranny Shop and I did those seals all the time. They can be a bitch!!! :)

Re:Anyone replaced thier rear main seal?
 

tell me about it. i would take the old one in when i order the new one, but i don't think they'd recignize what's left of it.

;D

Re:Anyone replaced thier rear main seal?
 

Lol, yeah they can get a little chewed up, but just make sure it's the same seal. I'd hate to see you have to change it again because it leaks or something. :'(

Re:Anyone replaced thier rear main seal?
 

getting them out is easy, getting them back in and to seat properly is a bitch, just make sure its going in straight and use a big socket to tap it in.

Re:Anyone replaced thier rear main seal?
 

a big socket? lol, I'd like to see a socket big enough to fit a rear main seal (normally use a 3/8 extension as a punch, or a big seal driver).. lol, think your thinking of front crank seals, or tranny output seals shortyz.

Be sure to clean the varnish off the crankshaft..

Jeff

Re:Anyone replaced thier rear main seal?
 

they exist. :D

Re:Anyone replaced thier rear main seal?
 

Not everybody has a 4inch socket 1in drive in there toolboxes, lol