veracity

got a d16a6 in an si i'm workin on and the cam was seized up when car was bought. took a straight edge and feeler gages to the head expecting warp but is in spec. went to tear it apart to clean it and inspect valves, cam and caps and the cam/rocker caps were way overtorqued. put it back together to find 4 stripped holes and broke a bolt. i've got a dx head just sittin collecting dust and thought of just swapping the cam from the a6 into it. just wondering if this would cause any problems or if it's been done a thousand times. tried the search button but you know the story on that.

bitchasscracker

same cast just different cams

Bone1

A6 cam in a D15 = use a stock Y7/Y8 cam gear to correct the 1/2 tooth cam timing difference.

Stock Y cam gear is only $10 at your local dealership.....

bitchasscracker

isnt the b2 and a6 gear the same

ryan89crx

yes, but the deck heights arent. you need the y cam gear to correct the timing issue with the a6 cam

veracity

thanks for the info, guys. cuts down on a little trouble shootin i been doin on why timing's off in this car. got that b2 head on there now with b2 gear. got a few extra y gears in the garage. there are benefits to working on 3 cars at the same time hadn't even considered that gear yet.

Bone1

Y7/Y8 cam gear is only $10 from the dealership.....

Y7 cam gear on a Crane 251-0012 cam, made 121 whp on a Mustang dyno





It was I who figured out the 1/2 tooth timing difference.........

88dx

why not just get a re-grind cam for the b2? Sweet power on the 1.5

Bone1

because a regrind won't have as much lift as the A6.....and you can usually find A6 cams for free.

veracity

impressive dyno sheet for that motor. just a little improvement over stock . might have to consider orderin up a cam like that. you pull that on a stock tune or what you tune it with?