91 Si DOHC ZC SWAP.....CODE 9...LIMP MODE...3100rev limit...SEARCHED
ok guys here my problem...i have a 91 civic si with a DOHC ZC engine...it ran fine till swaped the tranny ....weird huh
just swaped the blown L3 for another L3 symptoms- - started the car and it idles @ 1200rpm - wont rev past 3100rpm - i got a code 9 (No. 1 Cyl Pos) - running rich the spark plugs are fueled up what i have done- - checked wires comming from the dizzy plug to the Cyl pos senser (DOHC ZC have it on the exhaust cam) -had spare sensor and swaped it out (still ran like the same, i did reset the ECU 10amp HAZARD fuse) -i did check the cam timming and thats dead nuts. did i forget a ground somewhere? where else can i look where dose it get its ground side on the circuit...threw the ecu everything went well except this..... |
Re: 91 Si DOHC ZC SWAP.....CODE 9...LIMP MODE...3100rev limit...SEARCHED
code 9 doesnt put your car into limp mode. i know because i ran mine for over a year with that CEL. so 1st, check for other CELs that flash after that one.
i found out that mine was a bad wire in my harness just above the ECU. 16yr old wires tend to be a bit brittle, and apparently it jsut broke. fixed it, and fixed my problem |
Re: 91 Si DOHC ZC SWAP.....CODE 9...LIMP MODE...3100rev limit...SEARCHED
sounds like a place to start what does casue car to go into limp mode
|
Re: 91 Si DOHC ZC SWAP.....CODE 9...LIMP MODE...3100rev limit...SEARCHED
what dizzy are you using????
did you wire in the cam position sensor,or are you running straight dizzy?? |
Re: 91 Si DOHC ZC SWAP.....CODE 9...LIMP MODE...3100rev limit...SEARCHED
Originally Posted by Racintweek
what dizzy are you using????
did you wire in the cam position sensor,or are you running straight dizzy?? |
All times are GMT -5. The time now is 11:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands