mizter_2

i put a 16 valve b7 head on a 8v b8 block and it runs funny, what ECU should i use for this set up?? i have a PO5 and a PO6, next question is, the motor wont rev past 3,500 RPM, it just reaches 3,500 then drops down to about 2,000... and i do have a CEL. dunno the code that its throwing but will try to find out, and is there any home diagnostics i can do

whiterice

did you use the b7 intake mani & tb?
use the P06 ecu if you have it.
count the cel and post it.

mizter_2

for the CELs, i get 3 flashes and then 3 more flashes, i belive that means code 33? not too sure but if any one knows what that code means or what the flashes mean then let me know ASAP!! thanks

Donald125

don`t you like the torkyness from the 8 valve?

was it blink-----blink----blink
or blink.blink.blink.

long blink - first dight, fast blink = second digit.

mizter_2

it was blink-blink-blink pause blink-blink-blink

Donald125

that`s code 3 then

just look it up it is map sensor

boosted_b16

means the vacum line on the map sensor is unhooked, hence why it wont rev up and idles funny.....

mizter_2

alright thanks guys i'll go check it out and ill get back to you on what happens...