89 crx code 1 New o2 beating head against wall
#1
89 crx code 1 New o2 beating head against wall
ok for about two weeks i've been getting a code 1 so i figure the o2 had gone bad replaced code came back on test drive. ok so i figure bad connection i don't have a connecter on the o2 the wire runs from o2 to the harness and is soldered on both ends so i cut the wires resolder them heat shrink them and go for another test drive code comes back i am out of ideas so any help would be much appreshated
#4
Re: 89 crx code 1 New o2 beating head against wall
are you tinning the wires first? this happened to me and it was a loose connector to the dizzy and the ecu was throwing code 1 and 8(i think) when it i fixed the connection the code 1 went away. i know it is different then your situation but i would just check all the connections and see if any are loose. but if the car isn't in limp mode i would just drive it like it is.
#6
Re: 89 crx code 1 New o2 beating head against wall
put my voltameter on the o2 to check the voltage 0.4 at ideal and 0.6 at wot so i now the o2 is good and for the hell of it i put a new fuel filter figured the one from 89 was probley a little dirty but the code came back could it be the fpr maybe
#7
Re: 89 crx code 1 New o2 beating head against wall
heres a list of things i would check
spark plugs
plug wires
injecter wires
fuel pressure
dizzy wires
it sound like there is a problem that the ecu cant corect so it is throwing a code 1 because it is assuming everything else is working properly and has nothing else to blame the problem on
spark plugs
plug wires
injecter wires
fuel pressure
dizzy wires
it sound like there is a problem that the ecu cant corect so it is throwing a code 1 because it is assuming everything else is working properly and has nothing else to blame the problem on
Thread
Thread Starter
Forum
Replies
Last Post
Turblow
General Discussion
9
11-08-2006 12:35 AM