iwouldhitit

whos running a 6 puck?? can i use my stock flywheel and pressure plate? i have a b18b with a ys1 trans in my rex. ohh and can i use a 94+ clutch? wheres a good place to shop for clutch stuff

civicunrest

I have a 6 puck clutch. It was great until it got covered in oil (input shaft seal). You can use your stock flywheel, and I'm guessing stock pressure plate. I don't know about where to get them, though.

DOHCZCEF9

So why did your input shaft seal go out ? Also in case he's woundering if you get oil on your clutch ( i.e. rear main seal leaking , oil pan , etc. ) It will kill the clucth like that.

iwouldhitit

ok thanks ill make sure im careful

SLAY

You can use the stock plate and flywheel, you might want to have the flywheel re-surfaced unless its in good shape, also if you start to mod the car and get any major gains, youll need to replace the pressure plate, You should in due time replace the pressure plate none the less, as for the flywheel save up and get a lightened one, theres nothing worse then reciporcating weight.

200hp87Si

You can use the 94+ stuff. The YS1 trannys have the larger spline. They are the same as the hydro tannys. I'm running a solid disc 6 puc w/ heavy duty pressure plate, and lightened stock flywheel, and I love it.

civicunrest

I clipped the input shaft seal by accident when I last assembled my tranny. Oil will ruin a clutch.

I'm now running an ACT 4puck with an ACT 8.8lb flywheel. Get the lightened flywheel if you can afford it.