3 Bar map sensor De-install...
 

I have an Obd1 wiring harness with 3 bar map plug wired into it and I want to wire the old map sensor plug back on it. I was just wondering if anyone knew the wiring for the old plug. I know what the wires are Green/Red Map signal, Yellow Red 5v, & Green/White Ground I just don't which pins they go into on the old plug. I looked at my obd0 car but the colors are different. I can't find a wiring diagram for the actual plug, some help would be great.. ;)

Re: 3 Bar map sensor De-install...
 

I have the obd1 plug you need :y

Re: 3 Bar map sensor De-install...
 

I have a plug that works...just different colored wires. No one has an obd1 car that can look at their map sensor and tell me what colored wire is going into which pin? Someone please 2 mins of your time... :6

Re: 3 Bar map sensor De-install...
 

Well the colors might be different anyway. Your best bet it to take a couple minutes to use a DMM on the wires and you can easily tell which goes where.

Re: 3 Bar map sensor De-install...
 

Look inside the terminal of the stock MAP sensor. It has letters above each pin that tell you what each are.