Yeah haw! Nice start to the swap
Well I'm picking up a LS(a1) swap at my local pick and pull for 150 this saturday after work. I was looking around on eGay and found these and thought these would go for a boat load but holy ----! I can't believe I won these!!!! I'm so pumped!! 230ish shipped for eagle rods and srp slugs. 10.1 CR :-\ but I'll just get a cometic headgasket to drop it down some but hell b16's are already in the 10's and people have no problems so I may rock it the way it is and see if I have any problems with tuning it with the 10.1 cr.
http://cgi.ebay.com/ebaymotors/ws/eB...tem=7981364461 https://i24.ebayimg.com/01/i/04/4b/0f/27_1_b.JPG |
Re: Yeah haw! Nice start to the swap
nice deal! did he show you any pics of the "knick" in the description?
|
Re: Yeah haw! Nice start to the swap
Yeah, It's nothing.
|
Re: Yeah haw! Nice start to the swap
good buy..........wonder if you could just replace one piston?
|
Re: Yeah haw! Nice start to the swap
really good buy
|
Re: Yeah haw! Nice start to the swap
Just got an email back from JE and they go for 110 each if it's turns out to be too bad. I'm not too worried though. 8)
|
Re: Yeah haw! Nice start to the swap
watch your timing with high compression and boost, my sohc was 11.1 - 11.5 compression and 10psi on a 60/63 t3 kept blowing headgaskets.
|
Re: Yeah haw! Nice start to the swap
dirty ----
|
Re: Yeah haw! Nice start to the swap
Wheres the junk yard that your going located?
|
Re: Yeah haw! Nice start to the swap
Originally Posted by scottsi
watch your timing with high compression and boost, my sohc was 11.1 - 11.5 compression and 10psi on a 60/63 t3 kept blowing headgaskets.
D's are known for blowing headgaskets though. B's don't have headlifting problems |
Re: Yeah haw! Nice start to the swap
Originally Posted by Whitey
Originally Posted by scottsi
watch your timing with high compression and boost, my sohc was 11.1 - 11.5 compression and 10psi on a 60/63 t3 kept blowing headgaskets.
D's are known for blowing headgaskets though. B's don't have headlifting problems |
Re: Yeah haw! Nice start to the swap
Originally Posted by FooK
Originally Posted by Whitey
Originally Posted by scottsi
watch your timing with high compression and boost, my sohc was 11.1 - 11.5 compression and 10psi on a 60/63 t3 kept blowing headgaskets.
D's are known for blowing headgaskets though. B's don't have headlifting problems |
Re: Yeah haw! Nice start to the swap
I'll be picking up a set of ARP studs and a cometic gasket just for a safety precaution. I can't disclose my junkyard. I'll pm you the junkyard location and then once you click on the pm and read it. Just think of "The ring" and then your phone will ring and then your dead just cause you wanted some of my ----. :P
|
All times are GMT -5. The time now is 08:36 PM. |
© 2024 MH Sub I, LLC dba Internet Brands