jinxy

you're supposed to do that with the nut :P It's also pretty easy to undo.. A lot easier than a new alignment

Econo-Box

Dude I got a 3\4"drive ratchet, 32mm socket on it and 2 foot of pipe ....It didn't budge. I was jumping on it and doing everything I could. but like I said I need this ---- done and I was wasting time when there were other ways of getting the ---- out. I would rather align the car later than ---- up that nut more i was afraid I was going to round the bitch off if i kept ------- around.

jinxy

get a longer pipe

scottsi

2 foot is way short, you need like 5 feet and stand and jump on it.

Econo-Box

Alright so what you're telling me is that i should have used the whole jack handle and not just the top half. I'll try that next time, point taken.
so lemme ask yall this then, how do I get this little dude off so i can ****** the pile of poo out with the tranny. You like the AC dye everywhere right. lol I'm telling you it was a sweet show.

LilWayne

Dude u suck! if you were to unbend the bend in tab your axlenut might have came out now u look like an ***

LilWayne

and you don't need a chain drop it down then jack car up higher

Econo-Box

Ok I tried that tard, but i thought i was gonna round the nut off so i went about it another way. I doubt the overall success of this relies on If i managed to do it with or without pulling the axle.

My jack is real small and it would be extremely awkward to get the motor on it so i could get it from the bottom. I already have a cherry picker here why not use it and then get the motor on a stand easily and safely where I can work on it instead of on the ground.

Thanks so much for your concern though.

Bone1

who unbends the tabs?

I don't.


BBBRRRRAAAAAAPPPPPPPP.........zing!

Econo-Box

Hook it up bone how do i get that set key thingy out so i can bust the shify linkage at teh tranny? Do i just keep beatin on it?