Thanks for the write-up Jeff
 

So its a nice labor day weekend. I figure I'll tear down my d16y8 project block and notch for pistons and drill and tap for my endyne posts (arriving tues.) I hop online to get the instructions from Jeff's write-up, and there's no mention of what size to drill and tap the holes!!!!! So I just wanted to give a fat shout out to Jeff for his informative write-up. :P

Re:Thanks for the write-up Jeff
 

lol, yeah some words of wisdom please : :DD, yeah it'd like to know too, , , ,

Re:Thanks for the write-up Jeff
 

no need for gayness

Beau

Re:Thanks for the write-up Jeff
 

are all the posts the same size and thread pitch? i'd wait until they get there just in case. it'd suck to ruin the block if they have different one's.

Re:Thanks for the write-up Jeff
 

let know how the d16y8 pinning goes. i wanna do to my 2000 y7 so i figure they are exactly the same block wise. let me know if that d16y8 vtec also has piston squirters ;D

Re:Thanks for the write-up Jeff
 

notching for pistons?...u mean rods? Don't do too much, i think i did and im getting some piston slap

Re:Thanks for the write-up Jeff
 

lol im with you beau ::)

Re:Thanks for the write-up Jeff
 

[quote ]Posted by: Stealthmode
there's no mention of what size to drill and tap the holes!!!!! Wouldnt that depend on the size of the posts that you get.Im pretty shure they come in different sizes.

Re:Thanks for the write-up Jeff
 

well im assuming theres only one size because all i asked for were posts, all i did was take them to the parts store and ask for a tap

Re:Thanks for the write-up Jeff
 

Yes, notching for rods.lol. All I did was order the pins, too. No mention of different sizes. I'll post pics when I get this shindig finished. I'LL post the tap sizes when I get done. ;)