shifting a pulled tranny
05-02-2005, 01:04 AM
#1
0.5 BAR
Thread Starter
Join Date: Apr 2005
Posts: 140
shifting a pulled tranny
I had to replace the input shaft bearing in my 92 civic hatch. I put the stock tranny back together and the mainshaft turns smooth. I can pull the shift linkage in and out ( like 1st, neutral, 2nd). I tried to push and pull the shift linkage to the side to try to get it into other gears but it wont move that way. I would like to check all the gears before i mount it to the block. Is there a trick to doing this?
05-02-2005, 10:13 AM
#5
3.0 BAR
Join Date: Jun 2003
Posts: 1,558
Re: shifting a pulled tranny
remember, you twist the shifter to go to different gears, if the input is straight up and down you're probably doing 3rd and fourth, as that's where it should center. picture your shifter, and try to mimic the movements on the tranny. you can also try spinning the input shaft as the gears may simply not match up in the current position and without leverage they won't fall into gear...
05-02-2005, 06:39 PM
#6
0.5 BAR
Thread Starter
Join Date: Apr 2005
Posts: 140
Re: shifting a pulled tranny
Originally Posted by Mista Bone
did you lock in the countershaft snap ring before installing the shift interlock bolt?
If not you bent interlock which surronds shift arm "B"
If you bent that, have fun getting it out.
If not you bent interlock which surronds shift arm "B"
If you bent that, have fun getting it out.
Originally Posted by jung4g
remember, you twist the shifter to go to different gears, if the input is straight up and down you're probably doing 3rd and fourth, as that's where it should center. picture your shifter, and try to mimic the movements on the tranny. you can also try spinning the input shaft as the gears may simply not match up in the current position and without leverage they won't fall into gear...
05-02-2005, 08:54 PM
#7
0.0 BAR
Join Date: Jan 2005
Posts: 0
Re: shifting a pulled tranny
You'd still have 3-4, but no side to side, that what the slot is for.
Interlock Guide bolt is the LAST thing to go in. Without the counteshaft locked in, the shifter forks will sit low, not aligning properly. Installing the bolt will result in misalignment about 1/3 off the time.
Split it back apart and look, only takes 5 minutes. If you used Hondabond to seal the case, it cleans up easy with Autozone carb cleaner or anything tolulene based.
Interlock Guide bolt is the LAST thing to go in. Without the counteshaft locked in, the shifter forks will sit low, not aligning properly. Installing the bolt will result in misalignment about 1/3 off the time.
Split it back apart and look, only takes 5 minutes. If you used Hondabond to seal the case, it cleans up easy with Autozone carb cleaner or anything tolulene based.
05-03-2005, 12:32 AM
#8
0.5 BAR
Thread Starter
Join Date: Apr 2005
Posts: 140
Re: shifting a pulled tranny
all right got it figured out. put it in the nuetral position and twist it and push or pull. twisted the main shaft in all gears and it turns nice and smooth. thanks for the help now its time to put it all back together.
Thread
Thread Starter
Forum
Replies
Last Post
HMTguy
General Discussion
0
02-06-2008 09:35 PM
Sinner
Hybrid/Tech
18
12-06-2007 12:26 AM
