Raising compression using Jb Weld?
#33
Re: Raising compression using Jb Weld?
Originally Posted by rawr
it would serve like a little detonation pillow
#36
Re: Raising compression using Jb Weld?
[hit in the nuts] 240 deg... I was thinking more along the lines of sealing up a crack on the side of the block or something that's seeing coolant temperatures. Inside cylinder temps. are def. much higher.
If you want to try it, go for it. It's your engine not mine
If you want to try it, go for it. It's your engine not mine
#39
Re: Raising compression using Jb Weld?
Originally Posted by neuspeedescort
i would like to confirm that statement! why tear apart a motor to jb weld the piston dome. ------- replace the piston!
NEUMAN
NEUMAN
Thread
Thread Starter
Forum
Replies
Last Post
J-SMITH69
General Discussion
48
01-30-2008 11:40 AM