Quick chipping question
#21
Re: Quick chipping question
Originally Posted by nonvtec
I know it's not going to start anyway with the jumper cut because I am running 450's on a sohc, a stock GSR map will not start my car, I know this. No one's motor is going to be blowing up, I know what I'm doing for the most part and just had never done a p72 before. Yes JD you have my attention, ok I will take it out and look at it with a magnifying glass like you said, thank you for the help.
#22
Re: Quick chipping question
Originally Posted by Tatakai
sure it will. i managed to drive my GSR on stock p72 w/ 460's home from school and around the block a few times..
#23
Re: Quick chipping question
Alright I got it to start with the jumper pulled but, it's rough, and it floods and dies and then I clear flood it with the pedal floored and it will start again, but its ugly, which I predicted, now onto fixing my chipping solder job I guess.
#25
Re: Quick chipping question
Originally Posted by Joseph Davis
Lemme guess, bogged like a sumbitch around 3000 rpms, and you killed the sparkplugs? Also not good for the rings/bores, but do-able to move the car in a pinch.
Thread
Thread Starter
Forum
Replies
Last Post
turbohf
Engine Management
16
01-26-2005 07:42 PM