put vtec motor in crx
, im gonna need some when i start boosting the bitch.
05-25-2004, 09:06 AM
#25
1.5 BAR
Join Date: Mar 2003
Posts: 778
Re:put vtec motor in crx
use your crx injectors. the ones for the z6 or y8 wont work right, your car will sputter and idle like ----. i had them on my car for a while after my crx ones went bad. also, use the z6 or y8 (civic ex)fuel rail + fuel pressure regulator because the fuel rail flows a little better and the fpr has a little bit higher fuel pressure. if you dont do this you will probably get a code 1 cel(check engine light) when you hit vtec. it will take a little modification though. the ex fuel rail has two holes, but they dont fit the crx si manifold. what you need to do is measure the exact distance between the studs that hold your crx si fuel rail and drill three holes into the ex one.
by the way, locate your ecu in the passenger footwell under the carpet and count the number of blinks so you can tell us what code you are getting. im guessing code 16. if you cant figure that out, then you need to do a google search on how to pull crx check engine light codes.
by the way, locate your ecu in the passenger footwell under the carpet and count the number of blinks so you can tell us what code you are getting. im guessing code 16. if you cant figure that out, then you need to do a google search on how to pull crx check engine light codes.
05-25-2004, 02:51 PM
#27
0.5 BAR
Thread Starter
Join Date: Mar 2004
Posts: 155
Re:put vtec motor in crx
alright i put the A6 injectors and it still running funny 
, its still saying Check engine and i checked the ecu and it first blinks 14 times, then it stops and it resumes an additional 5 times. it does this over and over. What does that mean? Where do i search this?
, its still saying Check engine and i checked the ecu and it first blinks 14 times, then it stops and it resumes an additional 5 times. it does this over and over. What does that mean? Where do i search this?
05-25-2004, 03:00 PM
#28
3.0 BAR
Join Date: Jan 2004
Posts: 4,733
05-25-2004, 03:16 PM
#30
3.0 BAR
Join Date: Jan 2004
Posts: 4,733
Re:put vtec motor in crx
its probly one of these 2
05 Manifold Absolute Pressure sensor.. Reading too low or too high, defective MAP sensor
14 Idle Control System Malfunction.. Defective IAC valve, defective fast idle thermo valve, throttle body
you said it blinked 14 times then 5 times
just look in the link i posted
05 Manifold Absolute Pressure sensor.. Reading too low or too high, defective MAP sensor
14 Idle Control System Malfunction.. Defective IAC valve, defective fast idle thermo valve, throttle body
you said it blinked 14 times then 5 times
just look in the link i posted
