PUSHING CAR OFF CLIFF
ok well after swapping in a puny sohc motor last weekend, the car would run great but if i tried reving past 4k it would bog then be ok and bog again.
it started getting worst. then i couldnt rev past 3k and teh car would misfire. the tach was all over the place. i figured it might be the ignitor or coil going bad so i swaped them with the dizzy from my dohc motor in to the dizzy from the sohc. same issue. tach was still all over theplace. i would cruising at 2500rpms and the needle would be bouncing everywhere then the car would start to stutter. well on friday it started doing it again so i gavve it gas and then the car reved all the way to about 5k and then died. now i dont even get a ecu light and i dont hear the fuel pump. my afc wont turnn on either. the car will turn over. other electrical components do work like the windows and radio. i changed out the main relay and same ish. no blown fuses. i tried a different ecu same ish. now im thinking i may have had some type of currentt overload that was making my tach go nuts and mess with my dizzy. and when i managed to rev it to 5k it blew something. but what? help me :'( im tired of fixing crap. i just want to enjoy my dam boost. |
Re: PUSHING CAR OFF CLIFF
Change your coil and check your grounds??
|
Re: PUSHING CAR OFF CLIFF
when i had issues very similar, there were shorted wires inside the engine harness itself.
changed the engine harness...blam! good as new. |
Re: PUSHING CAR OFF CLIFF
I think you should do as the title of this thread states :P(sorrry.....I had to ;))
|
Re: PUSHING CAR OFF CLIFF
Originally Posted by d16forlife
I think you should do as the title of this thread states :P(sorrry.....I had to ;))
dam i dont know where the hell im gona find a complete harness to even try that :-\ |
Re: PUSHING CAR OFF CLIFF
what year accord? Did you bolt the wire harness ground to the intake manifold or the stat housing? That ground is CRITICAL
|
Re: PUSHING CAR OFF CLIFF
ja mang . i added two more grounds today. its a 91 accord ex
|
Re: PUSHING CAR OFF CLIFF
i might have an engine harness around here, but i dont think its complete, it might have a few wires cut on it... im not sure if that helps you
|
Re: PUSHING CAR OFF CLIFF
Renr take out all the ground wires and clean it up.
|
Re: PUSHING CAR OFF CLIFF
check you timing
|
All times are GMT -5. The time now is 02:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands