Project: Random Strike ::Pics:: (updated)
#31
Re:Project: Random Strike ::Pics:: (updated)
well if u made bbka's bin. then make that 4 hahahaha. that was a really good tune. my car ran really strong. it was my fault for going to 15lbs and abusing it hahaha. boost happy. i didnt think the dsm bov would be as loud as it was
#32
Re:Project: Random Strike ::Pics:: (updated)
Wow Random nice setup,but fix that damm leak..lol
Is that fan from Pep Boys?It looks like it moves some good air.
Is that muffler from a "stock" Crapmaro or is it an aftermarket one for a Crapmaro?
Is that fan from Pep Boys?It looks like it moves some good air.
Is that muffler from a "stock" Crapmaro or is it an aftermarket one for a Crapmaro?
#35
Re:Project: Random Strike ::Pics:: (updated)
Originally Posted by AbaZ
Whoa.. good work johnny..
So how about we trade boost gauges for me helping on the install I need one that goes to 30psi, I have the same one but just goes to 20.
btw, hows she rip?
So how about we trade boost gauges for me helping on the install I need one that goes to 30psi, I have the same one but just goes to 20.
btw, hows she rip?
it feels pretty fast, faster than my chevelle was... i think its in the high 13s or 14 flat. but its hard to tell cause 1st gear is a waste and it burns off the top of second.
it seemed like it only took a couple seconds to go from 65 to 125mph... and thats with 9lbs below 5000 and around 6 or 7 above that (need to get boost controller still) its on my list
the muffler is great, flows really good, and it quiet. these mufflers were originally made for the turbo chevy monza corvairs. but hotrodders started using them on their cars because they flow so good and are quiet at idle. like i said before i didn't notice a difference in acceleration between open DP and this exhaust setup. i really like it...
the fan is from carquest it was 125 dollars it better flow good... lol and it does
as for the ringlands... i want it dyno tuned i dont care how much its gunna cost
oohh and the tranny leak is still there... i replaced the output shaft seal and it still leaks a little bit. i need to take it out and split the case halfs and put some gasket stuff in there
Thread
Thread Starter
Forum
Replies
Last Post
Dr.Boost
General Discussion
35
05-30-2004 03:20 AM