HomemadeTurbo - DIY Turbo Forum
Page 3 of 4
1
2
3
4
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   General Discussion (https://www.homemadeturbo.com/general-discussion-6/)
-   -   New way to install gauges (https://www.homemadeturbo.com/general-discussion-6/new-way-install-gauges-89447/)

JoshMO 02-26-2008 09:10 PM
Re: New way to install gauges
 
interesting read... maybe I've been doing jew edits?

TorganFM 02-26-2008 09:39 PM
Re: New way to install gauges
 
Originally Posted by t_cel_t
i hope that pressure gauge is not hooked up becuase hes idleing
Oil temp, which is definitely high enough priority to frame in a big red piece of ----... /sarcasm

EG-prince 02-26-2008 09:43 PM
Re: New way to install gauges
 
Originally Posted by Mista Bone
sucks at running wires too........

http://i107.photobucket.com/albums/m.../RR/gauges.jpg

but at least he didn't get the 12billion rpm tach :)
Is that a pod made for the dash of an EG? if so, where do you get it?

JoshMO 02-26-2008 10:17 PM
Re: New way to install gauges
 
Originally Posted by EGgyLShatch
Is that a pod made for the dash of an EG? if so, where do you get it?
+1 on that ----.

Atticus 02-26-2008 11:37 PM
Re: New way to install gauges
 
1 Attachment(s)
this was my old set up
never running a tach like that again. came in handy considering the dx doesn't have one but it pissed the ---- out of me
the rest looked good. made it clean and covered the vent hole

Attachment 19741

SDRAWKCAB 02-26-2008 11:46 PM
Re: New way to install gauges
 
http://img455.imageshack.us/img455/9...turbo10xn9.jpg

TheDocta 02-27-2008 12:01 AM
Re: New way to install gauges
 
i was actually gonna run a boost gauge like that, but its easier to drill a hole in your windshield and run it straight :S

t_cel_t 02-27-2008 12:13 AM
Re: New way to install gauges
 
Originally Posted by TorganFM
Oil temp, which is definitely high enough priority to frame in a big red piece of ----... /sarcasm
no the gauge on the far right is pressure, and it says 0

TorganFM 02-27-2008 12:35 AM
Re: New way to install gauges
 
Good eye... he should probably push that car off a cliff anyway.

Bone1 02-27-2008 02:06 AM
Re: New way to install gauges
 
Originally Posted by EGgyLShatch
Is that a pod made for the dash of an EG? if so, where do you get it?
Autometer made it. Want it?

Clips are missing, you can see the bolt on the right and maybe the screws on the left I used to hold it into place. Then I drill three holes in the dash to run the wiring.


All times are GMT -5. The time now is 12:37 AM.
Page 3 of 4
1
2
3
4
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands