Need some help, whats the best way to get a race off of a hub.
 

I got the race out of the knuckle with a chizzle and about 1 solid hour of nailing it with a BFH. The race on the hub is giving me trouble though. If i had a vice I'm sure this would be 100x's easier, but does any one know a trick to this bitch using hand tools, or am I going to have to go back to the BFH and a screwdriver for another hour? I've got no gas to heat it either.

Re: Need some help, whats the best way to get a race off of a hub.
 

Try spliting the race with a hacksaw and then smacking it with a hammer.

Re: Need some help, whats the best way to get a race off of a hub.
 

take a cut off wheel and put a slice in it and get a chisle in in there. once u bust it loose u can take the chisel and and push it off.

Re: Need some help, whats the best way to get a race off of a hub.
 

best way? go buy a air compressor and a air hammer. :)

Re: Need some help, whats the best way to get a race off of a hub.
 

ended up tunameing it off with an angle grinder :8