i know this is the wrong place to post this.. but everyone see's this more then the right forum.


question: i got my B16 in and bolted. but the right axle will only go in a little bit. but it still has about an inch to go. i have the 90=93 teg axles like i'm supose to have. anyone know what is wrong?

edit - 2 vacuum hoses on top of the manifold on the back, what connects to those? both say 12, do they connect to the same spot as the previous engine?

 

hit it with a hammer.




p.s., i'm serious

 

I would think that as long as the hoses have a good vac source then it should run ok. Just run a spliter to them.