blu89crx

well i got my traction bar in today... ran into a few problems, but it wasnt to bad... well i took it for a spin and it rides like ----!!!! i mean i thought my car was going to fall apart... i think its b/c you have to remove the front motor mount for this traction bar.... when i let of the gas it like lerchs forward and my shifter almost pops out of gear and it makes bad sounds lol. somone help! l

so i need some help on what to do.... does jkmotorsports make a front motor mount for their traction bar... would getting new motor mounts help

SpankedYA!

Most people that have the bars have B motors where that is not an issue. I also noticed when I removed my front mount when I had an A6 that it did the same thing and I had to put the mount back in.

Loserkidwac

I installed my the other day a couple problems getting the bolts started but other than that pretty easy...did you realign the radius rods after you installed? I measured before and after and made them pretty much the same...oh and people seem to have a problem with this mount being so close to the axle but as JK has said before it will never contact it

88dx

I also installed mine last week for the most part everything went good. I hacked the radiator mounts off and welded them on the other side made for some more DP room

n2o_2k

Man, I should get off mys lazy *** and install mine.

Zeniceguycrx

holy ---- did someone raid his garage?

88dx

crxtc_com

I Installed HMT motor mounts in the other three mounts and i have not had an issue with anything.

Guy-Fast

contact the product builder not bash them on here

Minor Threat

B-series aftermarket mounts usually eleminate the front mount.

They're also made of polyurathane.

Do you have poly mounts?