identifying some srp pistons
 

met up with a guy to buy some CP pistons but they turned out to be srps. i ended up buying them cause they looked be be pretty good. and he threw in some eagle rods for a really good price.

suppose to be 81.5 bore. it clearly says srp up underneath it and it has 20 stamped on the opposite end of the srp im guessing thats bored 20 over stock??

Attachment 16041


Attachment 16042


Attachment 16043


Attachment 16044


Attachment 16045


Attachment 16046

Re: identifying some srp pistons
 

get a set of verniers and measure them. makes sense that the 20 would mean its .20 over

Re: identifying some srp pistons
 

Yes the 20 means .020 over. They were the same in my .020 over SRP's for my Y8. So yes they are 81.5mm. Now knowing the compression is the next question. How much did you pay for them?

Re: identifying some srp pistons
 

200 bucks for the rods and pistons

its hard to get a definate picture from JE/srp website but there is a dish to these pistons so i am thinking them are sub 9 to 1

Re: identifying some srp pistons
 

you got a steal.

Re: identifying some srp pistons
 

If the rings aren't binding, or wallowing up and down when you simulate a cyl wall pulling on them, those pistons are tits.

Also, when I saw you last month your hair wasn't that long, so this must be one of your untamed ginger pubes hanging off the right side of the skirt:

Attachment 16037

You might want to take care of that.

Re: identifying some srp pistons
 

guy told me he had cp pistons and eagle rods. we meet up and i see they are srps. told him i'd still buy em but they were connected to the rods and asked when hes gonna get them taken off. said he'd been selling them awhile and needed the cash fast cause hes going from turbo b16 to K swap. said hed take 200 for all em. i said SOLD!!!


to JD. nope no rings are binding at all, all oil and compression rings move freely 360 degrees. and no thats not a pube i let me hair grow cause i've been rocking a fohawk lately for the ladies...

Re: identifying some srp pistons
 

also to jd this shoulda been a pm but im lazy. i bought a manual boost controlelr on credit card. if i can get it hooked up fine ill rock this for awhile and get the ectune ebc setup later. with the new b16 tranny and my quaife lsd and those 14" DRs it dead hooks in 2nd gear and flyes. once i get the boost controller in and hooked up right ill come up lookin for some orange chicken and end up with 16psi muhahaha

Re: identifying some srp pistons
 

Don't worry about rotating the rings 360 degrees, worry about the ring wallowing up and down.

I am about to lay upon you some of the sweetest mspaint mojo you have ever seen, don't log off for the night or anything.

Re: identifying some srp pistons
 

http://img210.imageshack.us/img210/3...fpistongy3.png


:)