how much over bore???
i know absolutley nothing about SBC's. my buddy cracked a piston in his LT-1 and it ate up the cyl wall pretty good. how much of an over bore can he do and still be safe??
|
Re: how much over bore???
what block is it
|
Re: how much over bore???
lt-1 5.7l
|
Re: how much over bore???
i posting it on http://www.turbomustangs.com/forums/...?s=&forumid=20
|
Re: how much over bore???
well i know on the early style blocks you can go .0060 over safe i know this because i have did it may times without over heating problems but the lt1 i am not sure of the casting but i would guess the same. manufacturers usually offer pistons in the maximum overbore
so to make a long story short see what is offered far as replacement pistons and go look at the lt1 fourms |
Re: how much over bore???
"0.030 is safe.? 0.060 can be thin. Best bet is take it to a shop and have them sonic check ALL the bores. If the block has a lot of shift 0.030 may be too much. You can do a short fill in the block to to gain some strength. Or a tall fill?"
|
Re: how much over bore???
1mm should do it 20 over stock about the same deal.
|
Re: how much over bore???
.020 over is .5mm, .040 is 1mm
|
Re: how much over bore???
Originally Posted by Racintweek
.020 over is .5mm, .040 is 1mm
|
Re: how much over bore???
.030 is a standard punch out for a SBC/LT1, only ones you really have to watch is the 400's.........
You can punch the SBC .060 if needed, but core shift can bite you in the ass. |
All times are GMT -5. The time now is 12:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands