How do my numbers look?
#22
Re:How do my numbers look?
Should be gettin 180-190 on dohc zc that is very good condition. Same goes for most d series motors. 150 is signs of wear/tear on the motor. The importer I go through does not allow d series motors below 160 to be sold
#23
Re:How do my numbers look?
Originally Posted by trebor_nordap
i'd rebuild that dohc before going back to a single cam. i might cost even less to rebuild it. plus if you use forged pistons and rods. you'll have a much stronger motor then a stock single cam. even a dohc with stock pistons and stock rods will be stronger than a single cams' internals. oh and i'd spray the block with degreaser and let it get hot while running w/degreaser on so it would clean it. that stuff works good when it's sprayed on a warm engine and then let the engine get hotter while the degreaser is on.
#26
Re:How do my numbers look?
Originally Posted by bambooseven
I have a complete z6 head w/ mani. or an A6 mani bare. take your pic andmake an offer.
The only reason I was even running this motor was because it came with the car. I was planning on being stupid and blowing it up anyways.
We'll have to figure something out with those steelies. However Julio and I decide to do the swap.....
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#28
Re:How do my numbers look?
Originally Posted by Dr.Boost
Originally Posted by bambooseven
I have a complete z6 head w/ mani. or an A6 mani bare. take your pic andmake an offer.
However Julio and I decide to do the swap.....
Thread
Thread Starter
Forum
Replies
Last Post
Tell Me Turbo
General Discussion
5
02-18-2003 02:41 PM
S P E E D
General Discussion
21
01-05-2003 10:47 PM