mycrx

anyone reccomend what rod i should u, what about arc? i have some rod for roll cages and tubular ---- or lol seems like arc would take its toll on this piece of ---- when u touched it.

kain

hm.... just throw it away cus it will crack somewheres else. unless you can weld over the whole damn thing but then that would be a waste of time. just junk it and call its a loss.

J-MAN

it has to be rod made for bonding two differant metals together since the flanges are steel and the tubing is stainless. the rod i used is still holding but it was tigged. i will ask the guy that did mine to see how much he would charge to do another and if he has any of that rod left

Spenser

just brace the ---- out of it and hope it doesn't crack.

45psi

i told you i'd make you one, but nooooooo, had to be a cheapass.

dont use arc man, go with a oxy/fuel torch with some stainless filler. your going to get hella slag and contamination with the stick on stainless.

HondaTuner

Weld it, eBay it, and have 45psi make you another one.

mycrx

its not mine its a friends i know they are a piece of ------- ---- i've had one b4 but it didnt crack on me, any manifold should be braced and welded good, ---- even my friends lovefab mani collector ------- split in 2 on I-82 on night go figure

SpankedYA!

Thats funny, none of the manifolds that I made ever cracked.

Speedracer32

got damn sinister
whats up wit that avatar
she got phucked up

on topic i say scrap it too. put it on ebay or hang it in the garage

HondaTuner

Dumb broad ran in front of a runner. Oops :P