BLUEHATCH

i don't think that that is the problem because the car ran jsut fine before it got turbo

projekteg

well then more than likely clogged/bad injector(s), bad fuel pump, or maybe clogged fuel filter

98ctr

u said you put your new fuel pump on. Did you attached the screen to the pump? Put your oem fuel pump on and try that. It only takes 10 min's to do. 98ctr

BLUEHATCH

it ran like ---- with OEM fuel pump, so i thought maybe that was the problem (fuel pump not keeping up and ----) then i upgraded to walbro 190 and that didn't fix ----

projekteg

do you still have your stock injectors? put them back in and rescale your uber .bin for 240cc's, but don't boost more than about 5 or 6 psi b/c they'll be maxed out over that. if it runs fine like that, then your injectors are ----.

hotrex

only solution left i can thinkof, is to say ---- it, and smash your motor with a hammer :P

im stumped,

projekteg

you're stumped b/c you're an idiot

douspray

kevin used the same map on mine and i get just a little balck haze when i get into boost.

projekteg

actually, no, we tried that .bin but didn't go with it, that was the one that was running like total *** (before we set your timing back to stock of course :P ), but the actual .bin you're running was a straight up basemap with no changes at all to the fuel maps. they usually run rich in vacuum, but i think the only reason it doesn't run rich all the time is b/c of your high comp.

hotrex

or maybe cause im too smart