Re: Does anybody know how to take apart 450's?
 

If your so set on diy then do it. You don't seem to be listening to the advise were trying to give you. :3:7 Take them apart and clean them up and report back to us. "Hello...McFly..." Send them to RC and call it a day or diy and I hope they fall apart after you install them and you start a fire in your engine bay and then your whole car goes up in flames and you forget how to do the "stop..drop...and roll" and have a family member post pics of the carnage afterwards and then we tell you "We told you so." :-*

Re: Does anybody know how to take apart 450's?
 

hahahahhahaha, i could deffinatly see that happening also.

Re: Does anybody know how to take apart 450's?
 

Yeah.

Immerse in a bath of fuel injection cleaner or other non-polar solvent, turn on the machine, and pulse the injector so that the pintle + seat movement helps dislodge sediment in that area. If you have a spare intake mani/fuel rail, pump, bucket, and some fuel line you can also make a crude but serviceable injector test bench. Pulsing the injector a preset amount (555 timer or Injector Tester like I got for $60 off the Matco truck) you can both visibly observe spray pattern and measure the injector's output by spraying into a commonplace graduated cylinder.

It ain't rocket science.

Re: Does anybody know how to take apart 450's?
 

hammer.

Re: Does anybody know how to take apart 450's?
 

why didn't i think of that!

Re: Does anybody know how to take apart 450's?
 

rocking the same one but off the snapon truck, works tits

Re: Does anybody know how to take apart 450's?
 

i dunno kirk, it's only the obvious solution other than fire. But in this case fire would be step 2. ;)