DIY Conversion Harness Trouble...
#1
DIY Conversion Harness Trouble...
Has anyone bought a kit from xenocron? I have the kit and the conversion tables and it is way to confusing. If anyone has done one please offer up some help. I have checked the diagrams and they're not matching up. I have a harness and I used it for comparison and the differences are large. Help if you have conquered this small DIY project. I'm horrible at electronics, but reading diagrams I can do.
JP
JP
#4
Re: DIY Conversion Harness Trouble...
all you have to understand is how the OBD2 side is labeled and how the OBD1 side is labeled, match the 2 pinouts and run a wire between the 2 pins
this will probably get moved to the tech section
lots of pinout info and DIY harness stuff in that section already too
this will probably get moved to the tech section
lots of pinout info and DIY harness stuff in that section already too
#5
Re: DIY Conversion Harness Trouble...
what car are you doing....i can probably help you out a bit...... me and turbostd wired my car from obd1 to obd0 back to obd1 then to obd2....which it is now running on......it silly what youll do when you dont have any money
#8
Re: DIY Conversion Harness Trouble...
Originally Posted by BRIOHATCH
what car are you doing....i can probably help you out a bit...... me and turbostd wired my car from obd1 to obd0 back to obd1 then to obd2....which it is now running on......it silly what youll do when you dont have any money
Dan was right. OBD2a --> OBD1. I'm on break and wanted a little project so I picked this up to do. I have one I was going to make one though just for fun. PM me though if you think you can help and are willing too. Thanks alot.
JP
#10
Re: DIY Conversion Harness Trouble...
Originally Posted by jagojon3
Thought you were already running Uberdata?
JP