Cylinder Honing
 

anyone honed thier cylinders at home? as most of you know, my budget is getting smaller by the day, so i was wondering if anyone had any ideas. i have quite a bit of glazing on the bores, so i know i need to get that cleaned at least. i think the bores a re a bit outa round, but it seems only at the top. i can insert that piston easily into the cylinder, and more it up and down with minimal effort, but there is still very little clearance on either side. i can turn the piston 360 with any resistance at the bottom and in the middle, but at the top, it gets EXTREMELY tight at about 180, but if i force it around, it get easy again. this is only a problem on my middle 2 cylinders, as the outer two have just slightly more resistance at the top than at the bottom. so, any ideas on home honing/de-glazing?

Re:Cylinder Honing
 

i've done it before, but not to a honda block. you need a air wrench and one of those deals with the blue balls all over it. then you just running it in and out of the cyclinder till it shines up.. or somethin...