HomemadeTurbo - DIY Turbo Forum - Crossmember bushings for my crx?

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)

- General Discussion (https://www.homemadeturbo.com/general-discussion-6/)

- - Crossmember bushings for my crx? (https://www.homemadeturbo.com/general-discussion-6/crossmember-bushings-my-crx-71517/)

Re: Crossmember bushings for my crx?

it seemed like no matter how much grease i would stuff in there it woudl find its way out and they would make noise, so i made little plastic caps to keep the grease from coming out. no problems since

Re: Crossmember bushings for my crx?

Quote:

Originally Posted by Snafubmx234

Does that innovate replacement crossmemeber, shown here - http://www.innovativemounts.com/Show...x?prodid=59111 - utilize the stock strut rods? I'm assuming it does, and with those bushings, will be just like any other traction bar out there.

That's pretty much what I made for my car. Jigged it up on my junk crx using steel from Lowes, mostly just wanted extra clearance for my old turbo setups. Total cost was probably about $30 worth of steel and about 3-4 hours of my time. It works pretty well, but you still run into issues if you're car is lowered...pushes or pulls the lca's out of wack depending on how far you lowered the car. And the shitty part is you can't change your caster with this setup. :P It did help eliminate some wheel hop though.