Crimping 4 ga ring terminals
Does anyone have a really good ghetto way of doing this? I can't seem to find any wire crimpers that crimp 4ga and I've tried visegrips, a vise, pliers, etc and nothing gets a really good hold on the wire. I can always pull it out with moderate force. I'm hoping there is some trick that I'm missing to do this..
|
Re:Crimping 4 ga ring terminals
Do you have a good set of wire crimps? If not, you can use a vise and some solder to get a nice connection, put the stripped end into the ring terminal and set them into the vise, drip some solder into at as you crush it with the vise. You other option is to buy some nicer terminals. Streetwires makes one that you ------ the copper out and then fold it over then thread on a cap, or theres the kind that uses and allen screw to bite into the wires. They're not horribly expensive. And definitly worth it.
|
Re:Crimping 4 ga ring terminals
I don't see how a pair of vise-grips wouldn't work. Crush half of the ring terminal at a time. Then crush the other way (rotate 90 degrees) if necessary to get one side under the other, then crush the crap out of the other side. You should end up with a nice tight connection.
|
Re:Crimping 4 ga ring terminals
I use a small bench vise, not vise grips. just smash It till you can't smash it any more, then if you're still worrieduse a hammer and punch, (or screwdriver) and punch it where its flattened.
|
Re:Crimping 4 ga ring terminals
when crimping my 2 GA terminals i used a hammer and flathead screwdriver on the little pieces that are supposed to crimp, just bang it on both sides until the go down. then throw some solder on it to make sure it holds.
|
Re:Crimping 4 ga ring terminals
I have accesss to an industrial crimp tool(very expensive tool). The funny thing is I never used it on my connections. ::) I just stuck the wire in the connector and wrapped it with tape to hold it in. ::) The car isn't mine anymore so I don't care. :P
__________________ Best Car Insurance | Auto Protection Today | FREE Trade-In Quote |
Re:Crimping 4 ga ring terminals
just solder them w/ solid wire solder
|
Re:Crimping 4 ga ring terminals
ive used a vise before, just take a hammer and a punch to get it close and then crush it in a vise... worked for me
|
Re:Crimping 4 ga ring terminals
I just went ghetto ass wire cutters and a big ass hammer on my 4 gauge wire to my subs, held for a year in 2 different cars now
|
Re:Crimping 4 ga ring terminals
Ive done 1/0 gauge by putting the wire into the terminal, then take a big ass flat blade screwdriver and hit it with a hammer to crimp it down. Repeat as necessary.
|
All times are GMT -5. The time now is 10:42 PM. |
© 2024 MH Sub I, LLC dba Internet Brands