Can Someone help me put my clutch in please? Everett 98292 WA
Can someone please give me a hand doing this? I've never messed with a clutch while it was still in the car. If someone could just stop by for 15 min and point to a few "tricky" things they've learned through experience that would be great. Its a 95integra -
thanks, Jake |
Re: Can Someone help me put my clutch in please? Everett 98292 WA
loosen wheel lugs, jack front of car up take axles off, unhook trans linkage, take slave cylender off at the tranny but dont disconnect the hydrolic lines to it, drain transmission fluid, disconnect the speed sensor, starter and everything else hooked to the tranny. unbolt tranny from block. take mounts off let the transmission slowly drop with a jack under it or a hoist on the top of the motor. pull transmission off. wash hands good. take off presure plate put new clutch disk in, make sure you dont have it turned around. stick in alignment tool. bolt new presure plate on in the right sequence and tork to spec. reinstall transmission.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
its pretty easy man
gonna change an auto tranny tonight also make sure u dont damage any sensors |
Re: Can Someone help me put my clutch in please? Everett 98292 WA
98292? Thats a stanwood area code... where exactly do you live? if you do not mind me asking.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Well, now my cars going to get stolen :D jk, but im by Hagen. (stanwood)
I'll get a 24 pack, I just need some guidance- anyone? ??? |
Re: Can Someone help me put my clutch in please? Everett 98292 WA
LOL... Car stolen in STANWOOD? come on now. I live out in the warm beach area.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Oh, your so close dude, 3 minutes away, can u please help! And there are soooo many ------- thiefs in Stanwood , you have no clue.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
You live in those apartments behing hagen? and Im not the one you want helping you with your clutch... trust me. Im still learning and I would prolly only help you ---- it up.. if anything.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Nah, i live in a little development near there. thanks any ways.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
I'll pick up the car and do the clutch job (not including parts) for 150 out the door
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Originally Posted by AbaZ
I'll pick up the car and do the clutch job (not including parts) for 150 out the door
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Originally Posted by AbaZ
I'll pick up the car and do the clutch job (not including parts) for 150 out the door
But seriously just do it, they are pretty easy. the first one i did i thought it was going to be hard but it wasnt, if you dont already get a manual, tells you everything if you arent sure yourself. |
Re: Can Someone help me put my clutch in please? Everett 98292 WA
i live in marysville, too bad i don't know ---- bout it....go through Jeff
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Originally Posted by b18bturbo
Nah, i live in a little development near there. thanks any ways.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Hey thanks guys, im not paying for my clutch to be done ::) I just needed a lil help getting started. thanks again,
jake |
Re: Can Someone help me put my clutch in please? Everett 98292 WA
pull trans out new clutch in done oh and you better have atleast a half ass amount of tools if not have fun scramblin
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Yea there are alot of broke ass theives up in stanwood, My ex went to standwwo H.S back in the day and for a while rented a place behind hagen.
I have taken a few trannys out for like lunch and beer I could proably help you do it :P |
Re: Can Someone help me put my clutch in please? Everett 98292 WA
my first stolen crx was recovered in stanwood... imagne that :-\
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Can someone go overthe slave cylinder procedure .. i dont know what the ---- to do. Wheres the bleeder?
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
You dont take the lines off or even tap into the system at all. Basically just take the cylinder off the tranny. Remove the 2 12mm bolts and the one horseshoe clip for the line and hang it to the side.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Originally Posted by AbaZ
You dont take the lines off or even tap into the system at all. Basically just take the cylinder off the tranny. Remove the 2 12mm bolts and the one horseshoe clip for the line and hang it to the side.
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
thanks guys, sorry LSD, even after 5 im's i still didnt get it ???
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
http://www.honda-acura.net/forums/sh...d.php?t=139802
This is for a 6th Gen Civic. Basic idea. My Dad and I did mine and last weekend my buddies and I took out a Neon Tranny so it's all on a basic principle I guess. I'm sure if you searched you could find your application or atleast a B-Series. Heck, just ask Hotsex, if me and my ------ Dad can do it a school girl can. JP |
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Hey , thanks for all your help guys, installation went smooth. appreciate it -
|
Re: Can Someone help me put my clutch in please? Everett 98292 WA
Originally Posted by b18bturbo
Hey , thanks for all your help guys, installation went smooth. appreciate it -
|
All times are GMT -5. The time now is 10:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands