busted out the cam and got pictures of the old wpa welder
#1
busted out the cam and got pictures of the old wpa welder
needs no explination. 100amp sticky, 10% duty at 70amp, which is ------ pathetic.
but yeah, this is old school, my $300 hf gas/flux mig should be here tomorrow. will post up fluxcore madness y0
#5
Re: busted out the cam and got pictures of the old wpa welder
Originally Posted by BirdmanMD
10%!!!
do you do alot of sitting around when you weld?
do you do alot of sitting around when you weld?
#7
Re: busted out the cam and got pictures of the old wpa welder
Originally Posted by BirdmanMD
hmt'ing your welder for hmt welding.... i likes
i can blow through 5/16" plate at 100amps because of the 48v at max amperage output. makes keeping the puddle tricky but it really gets the job done slightly uglier than usual, and at less amperage. its kinda fun, can almost cut 1/4" plate with it ---- plasma, im all for epectrode madness yo.
i picked up a 130amp mig off of hf the other day:
For use with or without gas. Comes with welding torch, tip, 2lb spool of .030" flux core wire, grounding cord with clamp, brush/hammer, hand held welding mask and manual.Welds mild steel as thick as 18 gauge.
Input: 230V, 60 Hz, single phase; Welding current range: 30-120 amps; Duty cycle: 15% @ 115 amps; Draws 15 amps @ 230V; Max. open circuit voltage: 36V; Weldable wires: .023", .030", and .035 steel or stainless steel; .030" and .035" aluminum; .030" flux core
$399.99 from to $299.99, i got one that was returned because lack of instructions and box damage, soo... i pay $159.99!
Thread
Thread Starter
Forum
Replies
Last Post
ichbinsobose
Turbo Parts For Sale
0
11-04-2007 04:45 PM
J-SMITH69
General Discussion
9
12-27-2003 03:50 AM